How to access equipment within cabinet myHotTub

28 August, 2024

Please provide clear access to all side panels and equipment within the cabinet of your myHotTub

Please be mindful of where you position your new spa so you have 600mm clear access to all side panels and equipment within the cabinet. This will be needed for initial installation and also ongoing general maintenance.

 

 

How to remove the cabinet door panels

 

 

 

Plumbing & equipment within the cabinet

 

 

 

Technical specifications : equipment placement within cabinet

 

 

 

myHotTub electrical cabling access

myHotTub DOES NOT have this corner recess option due to steel frame so please ensure that you've considered power access prior to installing myHotTub. Pre-installing power through your concrete slab is the best option for power supply to myHotTub. The access from rear of spa will then be run through the myHotTub cabinet by your electrician to reach the main controller box. 

IMPORTANT : the electrician should install the conduit or flex so that it rises from the concrete slab at a MAXIMUM height of 40mm above the slab surface. If the conduit is higher than 40mm, it may interfere with the equipment within your spa cabinet, which could necessitate further work by your electrician and delay Sapphire delivery date.

 

Electrical cabling access : THROUGH CABINET

 

Electrical cabling access : PRE-POWER IN CONCRETE SLAB

 
 

Technical specifications showing measurements of where to position conduit to enter spa from base

 

  

 

×